Oil-Based Vent & Trim Spray

DIRECTIONS FOR USE

1. Abrade all bare wooden areas to a smooth, uniform surface. Tack with a water-dampened rag and let dry completely.
2. If floor has been stained, apply stain to vents and trim pieces
   following manufacturer’s label directions. Allow stain to completely dry before applying DuraSeal^® VTF^™ Vent and Trim Finish in your desired sheen.
3. Shake can vigorously for two minutes and repeat for 10 seconds after each minute of use.
4. Hold can vertically approximately 12 inches from surface. Spray using an even, sweeping motion, slightly overlapping each stroke.
5. Apply in thin uniform coats to avoid runs and sags.
6. Allow product to dry at least 30 minutes between coats. Subsequent coats can be sprayed without abrading if applied within 2 hours. If more than 2 hours has passed, allow finish to dry at least 4 hours before lightly abrading and tacking with a water-dampened rag. Apply additional coats until desired appearance is achieved.
7. After each use, clear valve by holding can upside down and spraying until only clear gas comes out. If spray button becomes clogged, wear eye protection, wipe off the button opening with lacquer thinner – DO NOT stick pin in spray button opening. Dispose of in accordance with local, state, and federal regulations.

DRY TIME

Allow product to dry at least 30 minutes between coats. Subsequent coats can be sprayed without abrading if applied within 2 hours. If more than 2 hours has passed, allow finish to dry at least 4 hours before lightly abrading and tacking with a water-dampened rag.

CAUTION

After each use, clear valve by holding can upside down and spraying until only clear gas comes out. If spray button becomes clogged, wear eye protection, wipe off the button opening with clean warm water – DO NOT stick pin in spray button opening. Dispose of in accordance with local, state and federal regulations.

CLEAN-UP

Mineral Spirits

104 – 119 sq. ft. / gallon

Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50° C/122° F

Nozzle Care:

1. After each use, clear valve by holding can upside down and
   spraying until only clear gas comes out.
2. If spray button becomes clogged, wear eye protection, wipe off the button opening with a regionally compliant cleaner, following manufacturer’s safety instructions — DO NOT stick pin in spray button opening.

FIRST AID

In case of eye contact, flush thoroughly with large amounts of water for 15 minutes and get medical attention. For skin contact, wash thoroughly with soap and water. In case of respiratory difficulty, provide fresh air and call physician.

DELAYED EFFECTS FROM LONG-TERM OVEREXPOSURE.

Contains solvents that can cause permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal.

WARNING

This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

DO NOT TAKE INTERNALLY.
KEEP OUT OF THE REACH OF CHILDREN.

DANGER

Extremely flammable aerosol. Contains gas under pressure; may explode if heated. May be fatal if swallowed and enters airways. Causes serious eye irritation. May cause respiratory irritation. May cause drowsiness or dizziness. Suspected of damaging fertility or the unborn child. May cause damage to organs through prolonged or repeated exposure.

GENERAL

If medical advice is needed, have product container or label at hand. Keep out of reach of children. Read label before use.

PREVENTION

Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Do not spray on an open flame or other ignition source.

PRESSURIZED CONTAINER

Do not pierce or burn, even after use. Do not breathe dust or mist. Wash hands thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear eye or face protection.

RESPONSE

IF SWALLOWED: Immediately call a POISON CENTER or physician. Do NOT induce vomiting.

IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a POISON CENTER or physician if you feel unwell.

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention if you feel unwell.

If eye irritation persists: Get medical attention

DANGER: Rags, steel wool, other waste soaked with this product, and sanding residue may spontaneously catch fire if improperly discarded. Immediately place rags, steel wool, other waste soaked with this product, and sanding residue in a sealed, water-filled, metal container. Dispose of in accordance with local fire regulations.

DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE.

Contains solvents which can cause permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal.

WARNING

This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Please refer to the SDS for additional information. Keep out of reach of children. Keep upright in a cool, dry place. Do not discard empty can in trash compactor.
Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 33.7%
Emergency telephone number (216) 566-2917